3D printed active subwoofer - SW1

Our 3D printed full-range speakers needed something to beef up the lower end of the frequency spectrum. We set out to design a compact subwoofer that can be used together with our FR3 speakers. The result is a 13 liter enclosure with a 6.5″ driver, a matching passive resonator and a plate amp. The passive resonator allows tuning the resonance frequency to match room modes, for example. The plate amp can power satellite speakers and has a fixed high-pass filter. The low-pass cut-off frequency for the subwoofer can be adjusted and the level too, which means that this system can be easily mated with signal sources that do not have equalizing or DSP capabilities in themselves.

3D printing

The enclosure consists of two parts, which are glued together after printing. Total print time is about 100 hours and uses about 4 kg of filament. Support is only needed for the small recess where the plate amp is mounted. Dual-material printing is not needed. The mass of the enclosure can be increased by filling the walls with epoxy through the holes in the back. A geometry file for 3D printing a matching funnel is provided, too. 2 kg additional mass can be obtained this way.